What parameters and analyzers does Envitrace support?

Envitrace supports water and effluent parameters including pH, COD, BOD, TSS, NH3-N, TDS, DO, turbidity, flow, and chromium; stack and emission parameters including SO2, NOx, CO, PM2.5, PM10, and VOCs; ambient air parameters for CAAQMS including AQI, O3, NO2; and groundwater parameters including borewell flow, water level, and conductivity for CGWA compliance.

Does Envitrace support CGWA groundwater compliance monitoring?

Yes. Envitrace supports borewell flow meters, water level sensors, and water quality analyzers for groundwater users regulated by the Central Ground Water Authority (CGWA), with direct data transmission to the CGWA portal.

Supported Analyzers & Instruments — Envitrace by GPMSTech

Q: Can Envitrace integrate with my existing analyzer brand?

Yes. Envitrace integrates at the protocol and signal level — supporting 4–20 mA, Modbus RTU/TCP, RS-485, RS-232, and Ethernet — so most installed instruments from any brand can be connected without replacement.

Q: Does Envitrace push environmental data directly to CPCB/SPCB?

Yes. Envitrace supports regulator-direct API transmission. Where boards require direct credentials held by the plant, we configure API clients for secure direct submission and maintain local backup for audit continuity.

Analyzers

About Analyzers & Supported Instruments

Envitrace integrates with a wide range of analyzers and measurement devices used for CPCB/SPCB reporting. We focus on data quality, auditability, and regulator-ready exports.

Supported Parameters (examples)

pH COD BOD TSS NH3‑N Flow DO SO₂ NOx CO VOCs PM2.5 / PM10

Supported Interfaces

4–20 mA 0–10 V Modbus RTU Modbus TCP RS‑485 RS‑232 Ethernet Serial-to-IP gateways

Analyzer List

Parameter	Typical Interface	Use Case
pH	4–20 mA / Modbus RTU	Effluent and process control
COD	4–20 mA / Modbus	Effluent quality and CPCB reporting
BOD	4–20 mA	Biological treatment monitoring
TSS	4–20 mA / RS‑485	Effluent solids control
NH3‑N	Modbus / 4–20 mA	Industrial discharge monitoring
Flow	Pulse / 4–20 mA	Load calculation and mass balance
SO₂ / NOx	Modbus / Serial	Stack emission CEMS
PM2.5 / PM10	Ethernet / Modbus	Ambient air & fence-line monitoring

What vendors usually deliver — and what Envitrace adds

Typical vendor deliverables: analyzer hardware, datasheets, calibration certificates, on-site commissioning, AMC options.
Envitrace additions: remote telemetry, automated buffering & backfill, audit logs, CPCB-ready exports, direct API integration and migration support.

Compliance mapping & regulatory notes

CEMS/OCEMS and effluent reporting have parameter- and frequency-specific requirements. Envitrace prepares regulator-ready exports and supports direct API transmission in the regulator-directed model. Note: regulatory links and specific board variants are listed as placeholders and should be linked to authoritative CPCB/SPCB sources on publication.

Sample export schema (CSV)

timestamp,station_id,parameter_code,value,units,status,calibration_id
2025-11-24T09:00:00Z,STN001,PH,7.2,pH,OK,cal-2025-01

Downloads (placeholders): Sample CPCB export (CSV) • Analyzer datasheet (PDF)

Analyzer Brands We Work With

As a system integrator and data transmission solutions provider, GPMSTech sources and integrates analyzers from leading manufacturers whose instruments carry NPL verification certificates and meet CPCB/SPCB acceptance criteria. We supply and commission these instruments as part of complete OCEMS/CEMS monitoring solutions.

Endress+Hauser Vasthi Instruments Forbes Marshall Horiba India Envea India ABB India NEVCO Engineers Analyser Instrument Co. ACE Gas Analysers Fuji Electric India Emerson Process Management India Thermo Fisher Scientific India

Brand names listed are trademarks of their respective owners. GPMSTech acts as a system integrator and data transmission solutions provider. NPL verification certificates for the instruments listed are held by the respective manufacturers. Our role is to integrate, configure, and connect these instruments to CPCB/SPCB/CGWA portals via the Envitrace platform.

FAQs (short)

Q: Can Envitrace integrate with my existing analyzer brand?
A: Yes — we integrate at protocol and signal level (4–20 mA, Modbus, serial) so most installed instruments can be connected without replacement.

Q: Does Envitrace push directly to CPCB/SPCB?
A: Envitrace supports regulator-direct API transmission. Where boards require direct credentials held by the plant, we configure API clients for secure direct submission and maintain local backup.